Back to Blog
Gtr evolution weed eater6/13/2023 ![]() ![]() You don't have to leverage your savings to level your lawns. Install the cover onto the control handle assembly. Rotate the control handle assembly into alignment with the engine and the front handle.įully tighten the screws in the ring clamps to secure the control handle assembly. Install (but do not fully tighten) the (2) screws into the ring clamps. Position the control handle assembly on the main pipe.Īlign the metal ring clamps with the slots in the control handle assembly. Use a screwdriver to tuck the ignition wires into the channels along the inside of the control handle.Īlign the throttle cable with the grooves along the control handle (above the ignition wires). Reinstall the trigger lockout/throttle cable assembly into the control handle. Use long-nosed pliers to bend and lock the return spring into position behind the plastic tab in the control handle. Install the throttle trigger (and spring) into the control handle the shaft of the throttle trigger should align with the hole in the control handle. The upper arm should be seated against the upper portion of the shaft recess the lower arm should be seated within the notch on the throttle lever. Use long-nosed pliers to lock the return spring into position. Slide the new trigger return spring over the shaft of the throttle trigger. INSTALLING THE NEW TRIGGER RETURN SPRING 3. Use long-nosed pliers to remove the trigger return spring from the throttle trigger. It may be helpful to immobilize the trigger return spring with long-nosed pliers while removing the trigger. Lift the throttle trigger assembly away from the control handle. Lift the trigger lockout/throttle cable assembly away from the control handle. Remove the (2) screws from the clamps inside the control handle. Remove the cover from the control handle assembly. Remove the (4) screws from the cover of the control handle assembly. ![]() This article provides step-by-step instructions for removing and installing the trigger return spring on an Echo SRM-225 trimmer. Over time, the trigger return spring can break, resulting in a trigger (and throttle) that requires manual manipulation to open or close. The trigger return spring provides necessary tension for this trigger to operate smoothly. The trigger allows you to open and close the throttle on your trimmer. Whether you are a legendary landscaper or a weekend weed whacker, provides the parts, procedures and facts you need to fearlessly fix what fails you. String trimmer out of whack? It's time to face the fix. ![]()
0 Comments
Read More
Leave a Reply. |